Basic Function - ClearSounds CSC600ER User Manual

BASIC FUNCTION

1. Redial function
This feature allows you to redial the last number you have called by
one-touch operation.
a. Lift handset or press the SPEAKER
b. Press the REDIAL button to redial the last number called.
2. Flash function
Press the CALL WAITING button to terminate a call and institute a
dialling tone for another call or to get another call from "Call Waiting"
(a special telephone service).
NOTE: If you do not have any special telephone service, such as Call
Waiting, press the CALL WAITING
your current conversation.
3. Speaker function
To switch your call to speakerphone, press the
replace the handset in the cradle. To switch back, simply pick up the
handset. In the speaker state, you can make or answer a call.
4. Speaker volume adjustment
To adjust the speaker volume, move the
the right side of the unit to the desired position.
5. Receiver volume and tone select switch
You can adjust the receiver volume by sliding the
Also you can amplify the receiver volume and tone frequency
according to your own hearing requirements.
" Amplify Feature part of the manual for details. "
NOTE: The unit must be connected to adapter for the receiver volume
and tone adjustment.
button to get a dial tone.
button during a call may disconnect
SPEAKER button and
VOLUME switch located on
VOLUME control.
Please see the
8
B. To take attention to everything happens at home by remote
control whenever
To have the function, you need to turn on the "Auto turn on " and
remember the Pin code.
1. To turn on " Auto turn on "
When the LCD shows the SET SOS
confirm. Then select the Auto turn on
button to enter. The LCD shows
the "Auto turn on " function.
2. To set Pin code
When the LCD shows the SET SOS
confirm. Then select the Pin code
to enter. Enter the Pin code (up to 4 digits, and the default Pin code is
1234), then press DIAL button to confirm.
After turn on " Auto turn on " and set the Pin code, you can use the
function as follows.
After 10 times ringing is detected, the phone will be auto off-hook
the line (In this state, the user can hear the caller but cannot answer
the caller), and then generates two "bip-bip" tones to remind the
caller to enter Pin code to enter full speaker state. The caller enters
the Pin code, and then starts the conversation. Every about 2 minutes
later, the caller will hear two "bip-bip" tones. Press special buttons
~
(0 9,*,#) to continue the conversation. Otherwise, the line will be
disconnect automatically.
NOTE: When the phone is auto off-hook the line, the receiver can
press the SPEAKER button to enter full speaker state with caller. In
this way, there is no need for caller to enter Pin code.
menu, press the DIAL button to
menu and press the DIAL
ON/OFF . Then select ON to turn on
menu, press the DIAL button to
menu and press the DIAL button
17