Nuisance Prevention® Circuitry - Directed Electronics Hornet 740T Owner's Manual

1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the
The LED system status indicator will light solidly if you are
entering Valet® Mode and will turn off if you are exiting Valet® Mode.
R R e e m m o o t t e e - - C C o o n n t t r r o o l l l l e e d d V V a a l l e e t t ® ®
You can also enter or exit Valet® Mode by using the remote:
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The LED system status indicator will light solidly if you have entered
Valet® Mode and will turn off if you have exited Valet® Mode.
N N u u i i s s a a n n c c e e P P r r e e v v e e n n t t i i o o n n
Your security system has Nuisance Prevention Circuitry
prevent annoying false alarms. This circuitry is designed to prevent
repetitive trigger sequences due to faulty door pinswitches or envi-
ronmental conditions such as thunder, jackhammers, airport
noise, etc.
Here's how it works: If the alarm is triggered by the same sensor
or switch three times within a 60 minute period, your system inter-
1 1 0 0
Valet® switch within 10
seconds.
® ® C C i i r r c c u u i i t t r r y y
DRW-35
™ (NPC ™ ) to
2004 Directed Electronics, Inc.
©