Step 2 Getting Sound To The Speakers - Yamaha MG10XUF Owner's Manual

Quick Start Guide

STEP 2 Getting sound to the speakers

1.
Make sure that the [
panel is set to the [
2.
Connect the supplied AC adaptor.
q Connect the power adaptor with the gap of the
plug facing up, aligning it to the [AC ADAPTOR
IN] connector.
[AC ADAPTOR IN] connector
w Turn the fastening ring clockwise to secure the
connection.
e Plug the power adaptor into a standard house-
hold power outlet.
3.
Make sure that all switches on the unit are not
engaged ( ).
4.
Turn on ( ) the [PFL] switches for each channel
you are using.
NOTE
When you turn on the [PFL] switch for a channel, you can
monitor the signal for that channel through headphones con-
nected to the [Phones] jack. The level of the signal is also
shown on the level meter indicator, allowing you to more accu-
rately check signal levels. After checking levels, turn the [PFL]
switches off.
NOTE
When a [PFL] switch is turned on, the [PFL] indicator below
the level meter flashes.
10
MG10XUF Owner's Manual
/ ] switch at the rear
] position (power off).
[ / ] switch
5.
Turn all the level control knobs fully to the left (min-
imum) and lower all the faders fully. These include
the [GAIN] knobs (white), channel fader (white),
and [STEREO] fader (red).
6.
Set the equalizer knobs (green) to the center ""
position.
5
[GAIN]
6
Equalizer
5
Channel fader
4
[
PFL] switch
7.
If you connect a device with high output level, such
as a CD player or an electric keyboard, to one of the
channels 1 to 4, turn on (
the corresponding channel*.
Channel
[PAD] switch
NOTE
If you are using condenser microphones, turn on (
[PHANTOM +48V] switch.
5
[
STEREO]
fader
) the [PAD] switch of
) the