Cisco CISCO7206 Regulatory Compliance And Safety Information Manual page 12

Port Adapters
Note that in Figure 7, X indicates the clearance distances between the cards and between adjacent
cards and components, and Y shows the creepage path across the surface of an insulator and between
the two points indicated by X.
European Community Requirements
The BABT 605559 marking on the HSSI port adapters signifies that the port adapters meet the
United Kingdom's requirements for SMDS support as specified in BABT/TC/130 standards. The
marking is shown in Figure 8.
Figure 8
605559
The following operating conditions are required within the European Community:
The ports marked "Ethernet," "10BaseT," "TokenRing," "FDDI," "Console," and "AUX" are SELV
circuits. SELV circuits should only be connected to other SELV circuits.
Connection of power supply: the Cisco 7200 series routers are intended for use when supplied with
AC power from a power source providing 5A maximum at 110 VAC and 2.5A maximum at 240
VAC, 50 through 60 Hz, with the chassis fully configured.
Other usage will invalidate any approval given to this apparatus if as a result it ceases to comply with
EN60950:1992.
12
BABT 605559 Marking