ProForm PFTL517040 User Manual page 8

6. Insert the excess Wire Harness (98, 128) into the Right
Upright (107).
Set the console assembly on the Uprights (106, 107).
While a second person holds the console assembly, at-
tach the console assembly with four Console Bolts (78)
and four 5/16" Star Washers (77) as shown. Start all four
Console Bolts before tightening any of them; firmly
tighten the Console Bolts.
7. Lower the Uprights (106, 107) until the handrails are
touching the floor.
See the lower drawing. Position the Uprights (106, 107)
so that the treadmill Frame (38) is centered between the
Uprights.
Firmly tighten the four Upright Bolts (83). Then, raise the
Uprights (106, 107) back to the vertical position.
8. Attach the Latch Assembly (11) to the Left Upright (106)
with the two Latch Screws (74). Start both Latch
Screws before tightening either of them. Note: It may
be necessary to remove the Latch Screws from the Left
Upright before attaching the Latch Assembly.
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking
belt (see page 25). To protect the floor or carpet from damage, place a mat under the treadmill.
6
Console Assembly
98, 128
107
7
106
8
74
8
77
77
78
78
106
107, 106
Handrail
Top View
38
11
106
83
107