Grizzly G0611X Owner's Manual page 25

4.
Loosen the cap screw on the vertical fence
bracket shown in Figure 26.
Cap Screw
Figure 26. Vertical fence adjustment cap screw.
5.
Align the left-hand edge of the vertical
workpiece with the centerline of the cutter
when the tracer pin is in the "in" or cutting
position. This position will make the first cut
in the vertical workpiece half the width of the
cutter. Figure 27 illustrates this concept.
Note: If your workpiece width is not evenly
divisible by the template size, then setting the
fences for even cut distribution is a matter of
judging the best possible position by eye.
Vertical
Workpiece
Cutter Centerline
Aligned
with Edge
Vertical
Workpiece
Cutter Centerline
NOT Aligned
with Edge
Figure 27. Aligning cutter start location with the
vertical workpiece.
Model G0611X (Mfd. 07/15)
Vertical Fence
Bracket
Vertical
Workpiece
Even Cut
Distribution
Vertical
Workpiece
Uneven Cut
Distribution
6.
Remember the position of the left-hand edge
of the vertical workpiece on the vertical fence
scale, and move the vertical workpiece out of
the way.
7.
Align the right-hand edge of the vertical fence
with the same position on the scale from the
previous step, then lock the vertical fence in
place with the cap screw.
8.
Familiarize yourself with the horizontal fence
adjustment components in Figure 28.
Main Adjustment
Bracket
Cap Screws
Figure 28. Horizontal fence adjustment
components.
9. Loosen both cap screws shown in Figure 28.
Micro-Adjust Wheel
Micro-Adjust Bracket
-23-