Table of Contents
Advertisement
LEDs in the Volume section of the mixer surface will indicate the level in
real time. There are twelve LEDs in the Volume indicator, each capable of
displaying two levels, for a total of twenty-four visible lighted steps.
When a Channel is selected, the current volume is instantly indicated on the
LEDs. When no LEDs are lit, Channel volume is at its minimum setting.
Save
Recall
Group
To make changes to a Channel:
1
2
3
Pan LEDs
The Pan indicator is made up of five LEDs. The center LED is green. The
LEDs on either side of center are red. As you turn the P
will light in various combinations to provide the maximum number of
position indicators with the fewest number of lamps. At either end of the
display only one LED will be lit to indicate that the Channel is panned full
left or right.
When using linked channels (stereo inputs), the LEDs light in different
patterns, using a pair of LEDs on either side of the display to indicate the
width of the stereo field. When the stereo image has been collapsed to
mono, only the center green LED will be lit. In this case the stereo input
will be heard as mono.
Mixing
Start creating a monitor mix by selecting the first Channel you want to
hear.
Pan and Volume Controls
• Select a Channel by pressing its numbered button—the
button's upper LED will light.
4
5
6
7
• Rotate the V
OLUME
to the left to lower the volume
• While the Channel is still selected, you can also change the
Pan setting. Rotate the P
position of the Channel in the stereo field.
8
9
10
11
knob to the right to increase the volume,
knob left or right to change the
AN
Solo
12
13
14
15
knob, the LEDs
AN
Mute
In Recall
Mode All
Volumes
Zero
Select
Mute
16
21
Advertisement
Table of Contents
