VPN
Configuring a Site-to-Site VPN
STEP 1
STEP 2
STEP 3
Cisco ISA500 Series Integrated Security Appliances Administration Guide
General Site-to-Site VPN Settings
Click VPN > Site-to-Site > IPsec Policies.
The IPsec Policies window opens. All existing IPsec VPN policies are listed in the
table. The following information is displayed:
•
Name: The name of the IPsec VPN policy.
•
Enable: Shows if the IPsec VPN policy is enabled or disabled.
•
Status: Shows if the IPsec VPN tunnel is connected or disconnected.
•
WAN Interface: The WAN port that traffic passes through over the IPsec
VPN tunnel.
•
Peers: The IP address of the remote peer.
•
Local: The local network of the local peer.
•
Remote: The remote network of the remote peer.
•
IKE: The IKE policy used for the IPsec VPN policy.
•
Transform: The transform set used for the IPsec VPN policy.
Click On to enable site-to-site VPN, or click Off to disable it.
NOTE: Enabling the Site-to-Site VPN feature will disable the Teleworker VPN
Client feature.
If you enable site-to-site VPN, perform the following actions:
•
To add a new IPsec VPN policy, click Add. See
Policies, page
•
To edit an existing IPsec VPN policy, click the Edit (x) icon.
•
To delete an IPsec VPN policy, click the Delete (x) icon.
•
To delete multiple IPsec VPN policies, check them and click Delete.
•
To enable an IPsec VPN policy, check the box in the Enable column.
•
To manually establish a VPN tunnel, click the Connect icon for an enabled
IPsec VPN policy.
•
To manually terminate a VPN connection, click the Disconnect icon.
•
To refresh the data for site-to-site VPN, click Refresh.
293.
Configuring IPsec VPN
8
292