Mapping Wan Qos Policy Profiles To Wan Interfaces - Cisco ISA550 Administration Manual

Networking
Configuring Quality of Service
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Cisco ISA500 Series Integrated Security Appliances Administration Guide
Enter the following information:
• Class: Choose an existing traffic selector (traffic class) to associate with the
policy profile.
• Queue: For an outbound traffic policy profile, choose the queue for sending
the packets that belongs to the selected traffic class. This option will be
disabled for an inbound traffic policy profile.
• DSCP Marking: Choose the DSCP remarking value to assign the priority for
traffic.
• CoS Marking: For an inbound traffic policy profile, choose the CoS
remarking value to assign the priority for inbound traffic. This option will be
disabled for an outbound traffic policy profile.
• Rate-limiting: Enter the amount of bandwidth limitation in Kbps for the
selected traffic class. For example, if the policy profile is applied to inbound
traffic, the rate-limiting setting only applies to incoming traffic that belongs
to the selected class. The default value is 0 Kbps, which indicates that there
is no limit.
Click OK to save your settings.

Mapping WAN QoS Policy Profiles to WAN Interfaces

Use the Policy Profile to Interface Mapping page to apply the WAN QoS policy
profiles on the WAN interfaces.
Click Networking > QoS > WAN QoS > Policy Profile to Interface Mapping.
The Policy Profile to Interface Mapping window opens.
To edit the policy profile settings associated with a WAN interface, click the Edit
(pencil) icon.
The Policy Profile to Interface Mapping - Edit window opens.
Enter the following information:
• Interface: The name of the WAN interface with which the policy profiles are
associated.
• Inbound Policy Name: Choose an inbound policy profile for managing
inbound traffic through the selected WAN interface.
4
160