ProForm DTL33951 User Manual page 8

4. Attach each Extension Leg (63) with two 1" Tek Screws
(39) and a Thin Base Pad (67) as shown. Attach the
lower Tek Screw, without the Thin Base Pad, first.
Attach the two Thick Base Pads (57) to the base of the
Uprights (69) with two 1" Tek Screws (39).
Attach the two Wheels (66) with two 2" Bolts (64) and
two Wheel Nuts (32) as shown. Do not overtighten the
Bolts; the Wheels should be able to spin freely.
With the help of another person, carefully raise the
Uprights (69) to the vertical position.
See step 2. Tighten the two Handrail Bolts (37).
5. Hold the Console Base (47) near the Left Handrail (71).
Attach the end of the ground wire on the Console Base
to the indicated small hole in the Left Handrail with the
Silver Ground Screw (75).
6. Touch the Right Handrail (72) to discharge any static.
Insert the end of the Upright Wire (42) into the socket in the
bottom of the Console Base (47). The connector should
slide easily into the socket and snap into place. If the
connector does not slide easily and snap into place, turn
the connector and then insert it.
4
66
64
69
63
5
Small
Hole
71
6
72
8
69 66
32
32
57
39
63
67
39
Ground
Wire
47
75
42
64
39
57
67
39
47