Yamaha YZF-R25 Service Manual page 79

7. Meter assembly lead
8. Throttle cable (accelerator cable)
9. Throttle cable (decelerator cable)
10. Horn lead
11. Headlight lead (right)
12. Front turn signal light lead (right turn signal
light)
13. Front brake hose
14. Handlebar switch coupler (right handlebar
switch)
15. Coolant reservoir hose
16. Fuel tank drain hose
17. Frame
18. Fuel tank breather hose
19. Electrical components tray
20. Handlebar switch coupler (left handlebar
switch)
21. Main switch coupler
22. Front side cowling inner panel (left)
23. Front side cowling inner panel (right)
24. Fuel injector lead
25. Fuel rail
26. Spark plug lead
A. Place the left handlebar switch coupler, right
handlebar switch coupler, and main switch
coupler in the electrical components tray so
that the leads to the switches are routed
upward.
B. Insert the projection on the wire harness
holder into the hole in the frame.
C. To fuel pump
D. Route the headlight lead through the guides
on the front side cowling inner panel.
E. Insert the projection on the plastic locking tie
into the hole in the electrical components tray.
F. The main switch lead, left handlebar switch
lead, and right handlebar switch lead may be
routed in any order.
G. Fasten the main switch lead, left handlebar
switch lead, and right handlebar switch lead
at the white tape on each lead with the plastic
locking tie. Point the end of the plastic locking
tie outward. Cut off the excess end of the
plastic locking tie to 3 mm (0.12 in) or less.
H. Fasten the fuel injector lead at the white tape
to the fuel rail with a plastic locking tie. Face
the buckle of the plastic locking tie rearward
with the end pointing downward. Cut off the
excess end of the plastic locking tie to 3 mm
(0.12 in) or less.
I. Cross the throttle cables above the plastic
locking tie.
J. White tape
K. Fasten the throttle cable (accelerator cable)
and throttle cable (decelerator cable) with the
plastic locking tie. Be sure to route the throttle
cable (accelerator cable) above the throttle
cable (decelerator cable). Cut off the excess
end of the plastic locking tie to 3 mm (0.12 in)
or less.
L. Route the spark plug lead to the front of the
projection on the electrical components tray.
2-46
CABLE ROUTING