Error Message
Size Error DX
Size Mismatch
Toner Low
Wait for a while
Related Information
•
Troubleshooting
•
Replace Supplies
•
Replace the Drum Unit
•
Clean the Corona Wire
•
Print a Fax Stored in the Machine's Memory
Cause
The paper size specified in the printer
driver and the machine's paper size
setting are not available for automatic
2-sided printing.
The paper in the tray is not the
correct size and is not available for
automatic 2-sided printing.
The paper in the tray is not the
correct size.
If the LCD displays this message, you
can still print. The toner cartridge is
near the end of its life.
The temperature of the inside of the
machine is too hot. The machine will
pause its current print job and go into
cooling down mode. During the
cooling down mode, you will hear the
cooling fan running while the LCD
displays Wait for a while.
Action
•
Press and hold
to turn the
machine off, wait a few seconds,
and then turn it on again. Leave
the machine idle for 15 minutes
with the power on.
Press Stop/Exit. Choose a paper
size supported by 2-sided printing.
Paper size available for automatic 2-
sided printing is A4.
Load the correct size of paper in the
tray and set the tray for that paper
size.
Paper size available for automatic 2-
sided printing is A4.
Load the correct size of paper in the
tray and set the size of paper to the
tray.
Order a new toner cartridge now so a
replacement toner cartridge is
available when the LCD displays
Replace Toner.
Wait until the machine has finished
cooling down. Make sure all vents on
the machine are clear of obstructions.
When the machine has cooled down,
the machine will resume printing.
If the fan is not spinning, disconnect
the machine from the power for
several minutes, then reconnect it.
358