Dismounting/Mounting The Rocker Arm And Shock Absorber - KTM 400-660 LC4 1998-2005 Repair Manual

1
2
4
5
6
7
8
9

Dismounting/mounting the rocker arm and shock absorber

– Jack up the motorcycle (place on a firm and even surface), unscrew
and remove the two nuts
the rocker arm
– Slightly lift the rear wheel and pull out the bolt
3
– Remove the nut from the
– P
ULL THE LINKAGE ARM OFF BOTH BOLTS EVENLY BY HAND TO PREVENT IT FROM
CANTING
– S
UPPORT THE REAR WHEEL TO MAKE IT EASIER TO DISMOUNT
– Pull the rocker arm
remove.
4
– Remove the brake fluid reservoir for the rear brake cylinder and tilt
aside.
– Raise the rear wheel approx. 15 cm by placing it on a suitable object.
– Hold the shock absorber and remove the screw
shock absorber mount.
– Remove the shock absorber
swinging fork.
Use the same procedure in reverse to mount the shock absorber and
rocker arm.
TORQUES:
– Upper and lower shock absorber screw: 45 Nm
– Collar nut for the bearing bolt between the linkage arm and the
frame: 60 Nm
– Collar nuts for the rocker arm bolts: 100 Nm
1 2
, and the shock absorber screw
4
.
5
and take off the right linkage arm
!
CAUTION
.
4
out of the swinging fork attachment
9
by pulling it down through the
10-2E
3
on
1 .
6
.
!
.
7
and
8
on the upper