Storage - Kärcher 1.575-615.0 Operator's Manual

STEP 1: Re move detergent suc tion
tube from container and insert into
one gallon of fresh water. Open de-
ter gent metering valve. Pull trig ger
on spray gun and si phon water for
one minute. Close detergent valve.
S T E P 4 : P r e s s
trig ger to re lease
wa ter pres sure.
CAUTION: Al ways store your pressure washer in a
lo ca tion where the temperature will not fall be low
32°F (0°C). The pump in this machine is sus cep ti ble
to permanent dam age if fro zen. FREEZE DAM AGE
IS NOT COV ERED BY WARRANTY.
1. Stop the pressure washer, squeeze spray gun trig-
ger to release pressure.
2. Detach water supply hose and high pressure
hose.
3. Turn on the machine for a few seconds, until re-
main ing water exits. Turn engine off im me di ate ly.
4. Drain the gas and oil from the engine.
5. Do not allow high pressure hose to become
kinked.
6. Store the machine and accessories in a room which
does not reach freezing temperatures.
CAUTION: Fail ure to follow the above di rec tions will
result in dam age to your pres sure washer.
When the pres sure washer is not being operated or is
be ing stored for more than one month, follow these
in struc tions:
1. Replenish engine oil to up per level.
2. Drain gas o line from fuel tank, fuel line, fuel valve
and carburetor.
3. Pour about one teaspoon of engine oil through
the spark plug hole, pull the starter grip several
12
times and re place the plug. Then pull the starter
SHUTTING DOWN AND CLEAN-UP
STEP 2: Turn off the engine.
STEP 5: Disconnect the garden
hose from the water inlet on the
machine.
9.800-103.0 - M • Karcher HDS 615-617
On-Off
Switch
STEP 6: Disconnect the high
p r e s s u r e h o s e f r o m h i g h
pres sure out let.

STORAGE

grip slow ly until you feel increased pressure which
indicates the pis ton is on its compression stroke and
leave it in that position. This closes both the intake
and ex haust valves to prevent rusting of cyl in der.
4. Cover the pressure washer and store in a clean, dry
place that is well ventilated away from open fl ame
or sparks. NOTE: The use of a fuel additive, such
as STA-BIL
for mu la tion of fuel deposits during storage. Such
ad di tives may be added to the gasoline in the fuel
tank of the engine, or to the gasoline in a storage
con tain er.
After Extended Storage
CAUTION: Prior to restarting, thaw out
any pos si ble ice from pressure washer
hos es, spray gun or wand.
Engine Maintenance
During the winter months, rare atmospheric conditions
may develop which will cause an icing con di tion in the
car bu re tor. If this de vel ops, the engine may run rough,
lose power and may stall. This temporary condition can
be overcome by defl ecting some of the hot air from
the en gine over the carburetor area. NOTE: Refer
to the en gine man u fac tur er's manual for service and
main te nance of the engine.
STEP 3: Turn off the water
sup ply.
STEP 7: En gage
t h e s p r a y g u n
safe ty lock.
®
, or an equivalent, will minimize the
Safety
Latch