Install The Cisco Sns 3515 Or 3595 Appliance In A Rack - Cisco SNS3515 Hardware Installation Manual

Install the Cisco SNS 3515 or 3595 Appliance in a Rack

Install the Cisco SNS 3515 or 3595 Appliance in a Rack
This section describes how to install the Cisco SNS 3515 or Cisco SNS 3595 appliance in a rack.
Install the Side Rails
Warning: To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
Warning
precautions to ensure that the system remains stable. The following guidelines are provided to ensure your
safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack. When mounting
this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at
the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit
in the rack.
Statement 1006
Step 1
Attach the inner rails to the sides of the server:
Figure 5: Attach Inner Rail to Side of Server
1 Front side of the server
a) Align an inner rail with one side of the server so that the three keyed slots in the rail align with the three pegs on the
side of the server (see the figure above).
b) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs. The front slot
has a metal clip that locks over the front peg.
c) Install the second inner rail to the opposite side of the server.
Step 2 Open the front securing plate on both slide-rail assemblies. The front end of the slide-rail assembly has a spring-loaded
securing plate that must be open before you can insert the mounting pegs into the rack-post holes.
Cisco SNS 3500 Series Appliance Hardware Installation Guide
20
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
2 Locking clip on inner rail