Basic Operations; Adjusting The Volume - RocketFish RF-WHTIB User Manual

Basic Operations

Establishing Communication
between the Sender and Receiver
Units
To power on the System.
a. Press the button on the rear panel of Sender.
The LED indicator blinks to indicate that the
Sender is plugged in and in Standby mode.
Sender
b. Press the button on the rear panel of Receiver.
The LED indicator blinks to indicate that the
Receiver is plugged in and in Standby mode.
Receiver
c. The Sender and Receiver were pre-paired at
the factory. When an active link is established
between them, the LED indicators will be solid
on and will not flash.
Note: In case the indicators continue to blink
after 30 seconds, it means there is no
active link between the Sender and
Receiver. Try to connect the System
manually using the CONNECT button. For
more, please refer to "Troubleshooting" on
page 8.
To listen to the System.
a. Make sure the System is powered on, and
there is an active link between the Sender
and Receiver.
b. Turn on your amplifier. Play the audio or video
source at your amplifier. Enjoy using the
wireless audio system!
To power off the System.
a. Press and hold the power button for 2 seconds.
The LED indicator will blink quickly first and
then go off to indicate that the Sender is
powered off.
b. Press and hold the power button for 2
seconds. The LED indicator will blink quickly
first and then go off to indicate that the
Receiver is powered off.
Note: It is acceptable to leave both units powered
on when not in use.
.6.
Additional Operations
Placing the Receiver
To cope with your different specific needs, the
Receiver can provide you three ways of
placement.
1. Placing the Receiver horizontally on a level
surface.
2. Placing the Receiver vertically with the
supplied holder.
3. Wall Mounting the Receiver
6cm

Adjusting the Volume

After the System is set up, it is recommended
that a 1 time adjustment of the Receiver volume
is made.
The volume control on the Receiver unit is only
used to adjust the balance of the volume
between the front and rear speakers.
After the volume of Receiver is set up, always
adjust the volume using the volume control on
your amplifier whenever needed.
Note: The volume control on the rear panel of the
Receiver is only used during the set-up
process to establish the relative volume
between the front and rear speakers.
.7.