Tile And Grout Care - Winnebago HORIZON 40FD Manual

TILE AND GROUT CARE

–If Equipped
For tile and grout soiled with grease, grime
or soap scum, use a neutral pH, everyday-type
stone and tile cleaner formulated for use on
natural stone, ceramic tile and grout.
A concentrated tile and grout cleaner may be
needed to clean stubborn soils and stains in grout.
To maintain grout appearance, apply a
porous stone protector or grout sealer after the
grout has been cleaned and is thoroughly dry
(usually about 24 hours after cleaning).
Quality brand tile cleaning products may be
found at many flooring sales centers or home
improvement retail centers.
NOTE: Always follow manufacturer's
directions closely for best results, and
always test on a small inconspicuous
area before using on entire floor surface.
CABINETRY
Wooden items may be cleaned with a soft
cloth and a good quality wood finish cleaning
product.
Vinyl simulated wood panels may be cleaned
with a mild, water based cleaner and a soft cloth.
Do not use solvents on vinyl wood panels.
NOTE:Many cabinetry and furniture items
throughout this motor home are
constructed either partially or completely
of real hardwoods. Because of natural
variations in woodgrain density, slight
differences in stain hue may exist
between one item and another. This is the
distinctive character and beauty of real
wood.
MAINTENANCE & STORAGE
SOLID SURFACE
COUNTERTOP
Care and Maintenance
You can easily maintain the beauty of your
countertop with little effort, under most
circumstances, using a window spray cleaner,
warm soapy water or other general purpose spray
cleaner. You can also use liquid or gel-type
cleaners containing bleach. Because the material
is nonporous, stains cannot penetrate below the
surface and will nearly always disappear using
these cleaning methods.
If a stain has dried on, allow the cleaner or
soapy water time to soften the area, after which
the stain will wipe off.
If the stain is not water-base or oil-base
material, you may need to gently remove it using
a plastic scraper (disposable plastic knife for
example) followed by normal cleaning methods
described above.
You may want to scrub the entire surface
periodically. Do this lightly and evenly with a
mild abrasive powdered or liquid cleaner.
Always use a cutting board rather than
slicing foods directly on your countertop. The
underside of one of your sink covers will provide
an easily accessible cutting surface. This will
keep your countertop looking its best and
minimize care efforts. (An occasionally sanding
with a medium grade (120 grit) sandpaper will
remove any cut marks accumulated on the sink
cover bottom).
To remove cuts and scratches, use a more
aggressive cleaning powder such as Comet, a
moistened steel wool soap pad or green scouring
pad. We recommend that you finish the entire
surface using the same cleaning material and
scrubbing method to maintain a uniform
appearance.
If you prefer a glossier look, follow up with
a good quality furniture polish or a liquid
automotive wax (non-cleaner type).
Use trivets and 'hot pads' under hot cooking
pans. Do Not set hot pots or pans directly from
the stove or oven onto the counter. The solid
SECTION 11
11-7