Feature Module Leds - IBM 8275-416 User Manual

Feature module LEDs

Each feature module has an OK and a Fault LED located at the left side of the
faceplate. The OK LED is green and the Fault LED is yellow. LED locations are
shown in Figure 5, Figure 6 on page 14, Figure 7 on page 15, and Figure 8 on
page 16; LED status of the feature modules are explained in Table 5, Table 6 on
page 14, Table 7 on page 15, and Table 8 on page 16.
Status LEDs for the 8-port 10/100BASE-TX Ethernet feature
module
Figure 5. LEDs for the 8-port 10/100BASE-TX feature module.
Table 5. Status of LEDs for 8-port 10/100BASE-TX feature module
LED
OK
Fault
Right Ethernet
Port LED
Left Ethernet
Port LED
8-Port 10/100BASE-TX Feature Module
1 2
OK
Fault
Feature Port
Module LEDs
LED
Color
Green
Yellow
Green
Green
3 4 5 6 7
State Explanation
ON There is power to feature module.
OFF There is no power to feature module,
no power to the switch, or the module
has failed.
ON There is a module fault.
OFF There is no module fault.
ON Indicates a 100-Mbps port.
OFF Indicates a 10-Mbps port.
ON The link is up.
OFF The link is down.
Blinking Transmitting (Tx) and Receiving (Rx)
traffic.
8
Chapter 1. Introduction
13