Recovery Mode - Motorola PTP 600 System User Manual
Series point-to-point wireless bridges
Hide thumbs
Also See for PTP 600:
- User manual (250 pages) ,
- Parts list (38 pages) ,
- Deployment manual (23 pages)
Table of Contents
Advertisement
9
Recovery Mode
The Motorola PTP 600 point-to-point wireless Ethernet bridges have a special mode of
operation that allows the user to recover a unit from configuration errors or software image
corruption.
Recovery mode is entered by depressing the Recovery Switch located on the underside of
the PIDU Plus while applying mains power, as shown in Section
should be held in the depressed state for between 10 and 20 seconds after the application of
mains power. The Ethernet LED will flash with 10 double flashes at power up.
When in recovery mode the user will be able to access the unit via the Ethernet interface. The
Ethernet interface will have it's IP address set to 169.254.1.1 (or 10.10.10.10). On connection
to a unit in recovery mode the following screen is displayed (
Figure 96 - Recovery Mode Warning Page
160
3 .3.2. The Recovery Switch
1 1 5 5 H
F igure 96):
1 1 5 6 H
Advertisement
Table of Contents
