Assembly - ProForm 800 PFEL57907.0 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own Phillips screwdriver , adjustable
wrench , and rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
#8 x 1/2" M4 x 16mm #8 x 2"
Screw (79)–6 Screw (80)–4 Screw (68)–4
M8 Hex Nylon M10 x 22mm x
Locknut (77)–4 1.5mm Washer
(63)–2
M6 x 14mm M6 x 18mm Patch M8 x 19mm Patch M10 x 15mm Patch M10 x 27mm Patch
Flat Head Screw (57)–6 Screw (65)–4 Screw (71)–2 Screw (64)–4
Screw (55)–1
Barrel Nut (56)–1
M8 x 55mm Patch
Bolt (61)–4
M10 x 120mm Patch Screw (58)–2
5