Cleaning The Cold Plate (Yearly) - Cornelius SPIRE 4.1 Operator's Manual

Spire 4.1 Operator's Manual
Y M
EARLY AINTENANCE
Perform the following activities annually to maintain the unit:
1. Have the water pump and check valve inspected and cleaned, if necessary, by a qualified service technician.
2. Have the CO gas check valve inspected and cleaned, if necessary, by a qualified service technician.
2
3. Remove the splash panel and cold plate cover to clean and sanitize the cold plate surface. (See "Cleaning the
Cold Plate (Yearly)" on page 20).

Cleaning the Cold Plate (Yearly)

Perform the following steps to clean the cold plate:
1. Remove the Enclave from the unit.
To do this, see "Removing the Enclave (as Required)" on
page 23.
2. With the Enclave removed, check that the drain holes
(feeding the drain pan) are not clogged and remove any
debris from the drain trough to ensure proper drainage.
3. Locate the Cold Plate Access Covers.
On the Spire 4.1 unit, the cold plate access covers are
white plastic caps located on either side of the agitator
motor. See Figure 32.
4. Open the Cold Plate Access Covers.
To open the cold plate access covers, grab the top of the
cap and lift the cap from the unit. See Figure 33.
Publication Number: 620066826OPR
Enclave Enclave Enclave
Ice Slide
Drain
Holes
Cold
Plate
Access
Covers
Cold
Plate
Access
Opening
- 20 -
Figure 30
Figure 31
Figure 32
Figure 33
© 2017, Cornelius Inc.