Table of Contents
Advertisement
The Parent unit can be used with either the rechargeable battery pack (2.4V
600mAh Ni-MH rechargeable battery pack supplied) or via the power adapter
supplied.
WARNING:
Never use ordinary, non-rechargeable batteries. The power outlet adapter
provides a charging function, and non-rechargeable batteries may explode
and cause damage!
NOTE
The Ni-MH rechargeable batteries must be charged for 16 hours before using
the Parent unit without the power outlet.
We recommend the rechargeable batteries are installed, so that the unit
continues to work in the event of a power failure.
1. Using a screwdriver, turn the screw of the battery cover on the back of the
parent unit 90 degrees in a counterclockwise direction. Remove the
battery cover.
NOTE
Rotate the belt clip to its hanging position to make it easier to access the battery
compartment.
Do not try to turn the screw further beyond the OPEN position marked on the
cover.
2. Insert one battery pack with 2 AAA size Ni-MH rechargeable batteries.
3. Close the battery compartment and turn the screw back 90 degrees back
in a clockwise direction.
4. Press and hold
has battery power.
5. Press and hold
8
. The Power (ON /
to switch off the parent unit.
) LED will illuminate red if it only
Getting Started
Advertisement
Table of Contents
