Link - Motorola MBP10S User Manual

2.4

Link

NOTE
Do not place the Baby unit or cables in the crib or within arm's reach of the baby
(the unit should be at least 1 metre away).
When using the baby monitor for the first time, it is advised to test the
connection.
• Install the parent unit in the same room as the baby unit, but make sure there
is at least 1 metre between the 2 units.
• When both units are switched on, the parent unit will search for the baby
unit.
• The green link LED on the Parent unit will flash until the parent unit is
connected with the Baby unit. Once the link is established, the LED will stop
flashing.
• The sound captured by the microphone on the Baby unit will be audible on
the parent unit.
• The detected sound level is indicated by the LEDs on the front of the Parent
unit.
• When the connection is established, move the Parent unit to the room you
want to monitor from, but within the operational range.
• When there is no connection or the unit is out of range, the Parent unit emits
a warning beep every 20 seconds and the green link LED on the Parent unit
will flash.
• Move the Parent unit closer until the link is re-established.
2.5 Paging
If the parent unit is misplaced, press the
emit a repeated beep tone for 30 seconds so that you can locate it.
Press any key on the Parent unit, or the
10
key on Baby unit. The Parent unit will
again on the Baby unit, to stop paging.
Getting Started