Overstruck Smart Labels; Smart Label Characteristics - Printronix T5000e Series Quick Setup Manual

Overstruck Smart Labels

If an RFID tag within a smart label is deemed unacceptable after
execution of the defined number of retries, the following actions are
performed:
•
If Error Handling is set to Overstrike (the default), the
unacceptable smart label will print with a grid or error message
over the label. If the Label Retry Count is greater than zero (the
default is 10), the next smart label will be tried until the label
retry count is exhausted.
•
If Error Handling is set to Stop, the printer will stop, give an
error message, and discard the failing label data.
•
If Error Handling is set to None, the printer will continue to the
next smart label with the next form and discard the failing label
data.

Smart Label Characteristics

The smart labels currently supported have the following
characteristics:
•
UHF 915MHz radio frequency identification tag
•
EPC Class 1 tags – 64 data bits Write Few / Read Many
•
4 x 6 inch label stock
•
Nominal roll size is 500 smart labels. An additional number of
smart labels may be added to the Printronix smart label rolls to
compensate for tags that are deemed unacceptable. This is so
you can have 500 good labels.
NOTE: It is highly recommended that additional smart labels are
purchased directly from Printronix to assure the highest
level of performance and reliability. See "How To Order
More Smart Labels" on page 15.
Overstruck Smart Labels
13