Step 4 – Tap Installation - Zenith Econoboil 301642 Installation And Operating Instructions Manual

Step 4 – Tap installation
1. Fit the cover to the unit and fi x with
screws top and bottom.
3. Turn the tap fully clockwise to the end stop
and stopped at upright position.
Page 6 of 12
Installation Procedures
For a concealed electrical connection, disconnect the pre-fitted flex and
plug cable at the PCB connector and discard. Connect the concealed
power cable through the rear access opening to the green terminal
block on the PCB.
For concealed electrical connection, an isolation switch should be
installed.
Check that the earth is connected through the PCB to the chassis with
an ohm meter.
Warning: Do not connect both options. It is essential that the flex and
plug cable is removed from the PCB if the concealed connection is
used. Otherwise the GPO plug will become live.
Installation Procedures
Zenith Econoboil - Installation & Operating Instructions - 804544NZ - 03.17 v1.00
Continued
Continued
2. Before installing the tap, ensure enough
thread tape is applied to the thread.
4. Use the spanner to tighten the lock nut an-
ti-clockwise.
Thread tape
Lock nut