Read These Warnings First - Zenith Econoboil 301642 Installation And Operating Instructions Manual

Zenith Econoboil - Installation & Operating Instructions - 804544NZ - 03.17 v1.00

Read These Warnings First

Please read all installation requirements, installation procedures and
precautions before installing any Zenith Econoboil instant boiling water
heater.
Never attempt to install any Zenith Econoboil instant boiling water
heater without reading all of the applicable instructions.
In some hard water areas where mineral scale accumulation in the
boiling chamber of the Zenith Econoboil may become a problem,
consideration should be given to the maintenance required. A suitable
form of water treatment may be necessary.
The cold water supply to this appliance must be potable and fall within
your local authorities guidelines.
The Zenith Econoboil instant boiling water heater is not intended for use
by young children or infirm people without supervision.
Young children should be prevented from having access to ensure that
they are not able to use or play with the heater.
If the installation site is located more than 1000 metres above sea level,
the installer should contact Zenith for high altitude thermostat.
This appliance must be earthed. If the power supply cord is damaged it
must be replaced by a qualified electrician.
Do not remove the cover of the heater under any circumstances without
first isolating the heater from the power supply.
Do not use strong, corrosive or abrasive cleaners to clean the case of
the heater.
Frost protection: If this heater is located where ambient air
temperature could fall below 5ºC when the heater is not in use, do not
turn off the appliance electrically. This safeguard does not offer the
same protection to the connecting pipework and fittings.
The ambient temperatures this unit must operate within are 5ºC -
50ºC.
This heater is intended only for indoor use and should never be
installed outdoors or be exposed to the elements of nature.
This unit must not be positioned in an area that may be cleaned by a
water jet. This unit must not be cleaned by a water jet.
Installation Requirements
Before installing, ensure that the following are available:
a) Sufficient space to position the heater so there is at least 150 mm
clearance above the heater for service access, 65 mm to its left and
20 mm to its right – the tap outlet usually should be positioned at
least 200 mm above a draining board or drip tray.
b) Standard 220- 240 volt power cable positioned as shown on the paper
mounting template for connection from the rear of the heater to the
terminal block within the heater, OR a standard 10 amp 220- 240 volt
power outlet on the wall within 1500 mm of the heater. This switch
must provide all-pole disconnection and a contact seperation of at
least 3 mm installed in accordance with wiring rules, see Step - 3.c.
c) Cold water supply with a minimum working pressure of 70 kPa and
a maximum working pressure of 700 kPa connected via an isolation
valve.
Page 3 of 12