Related Manuals for Neilsen CT1503
Summary of Contents for Neilsen CT1503
- Page 1 CT1503 ORIGINAL INSTRUCTIONS Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K Read and understand the user and safety instructions before you use the tool.
-
Page 2: Ec Declaration Of Conformity
EC Directive based on its design and type, as brought into circulation by us. In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: DUAL-BEVEL SLIDING MITRE SAW WITH LASER Model: CT1503 Applicable EC Directives: EC Machinery Directive 2006/42/EC EC Directive of Electromagnetic Compatibility 2014/30/EU Harmonized standards：... - Page 5 45˚...
-
Page 6: Description Of Symbols
Please recycle where facilities exist. Check with your local authority or retailer for Laser Output power: ≤1mW recycling advice. Power cord length: Protection class: Weight: 15.5kg Conforms to relevant legislation and safety standards. As part of our ongofing product deveflopment, specfificatfions of NEILSEN products may aflter wfithout notfice. -
Page 7: General Power Tool Safety Warnings
- Use face or dust mask if working operations create dust Sound and vibration information WARNING: Not using protective equipment or appropriate clothing can cause personal injury or increase the Sound pressure L 93.5dB(A) severity of an injury. Sound power L 106.5dB(A) 10 - Connect dust extraction equipment - If the tool is provided for the connection of dust extraction and collecting equipment, ensure these are connected and properly used... - Page 8 WARNING: Before connecting a tool to a power source (mains switch power point receptacle, w) Inspect the workpiece and remove all nails and other embedded objects prior to starting work outlet, etc.) be sure that the voltage supply is the same as that specified on the nameplate of the tool. x) Do not apply any sideways or twisting force to the blade whilst cutting A power source with a voltage greater than that specified for the tool can result in serious injury to the user, y) If a cut does not extend to the edge of the workpiece, or if the blade binds in the cut, allow the blade to...
-
Page 9: Intended Use
40. Bevel Nut 52. Blade Washer 64. 0° Locking Nut transported with the cutter head lowered and secured by the Latching Pin (46); however, there is a small risk that vibration in transit could cause the Latching Pin to move allowing the cutter head to rise 41. -
Page 10: Adjusting The Bevel Angle
WARNING: Be sure to tighten the Mitre Table Locking Knob before making a cut. Failure to do so could result in 1. Loosen the Depth Adjustment Locking Nut and turn the Depth Adjustment Bolt (67) clockwise for a shallower cut or anti-clockwise for a deeper cut. The bolt contacts the Depth Stop (70) in use as the cutter head is the table moving during the cut, causing serious personal injury. -
Page 11: General Inspection
Storage and for the right side adjustment use 45° Right Bevel Bolt (59) and 45° Right Bevel Locking Nut (58). Loosen the applicable locking nut so it is at a higher position, and make a small adjustment to the bolt height (the adjustment should be very small) •... -
Page 12: Troubleshooting
Troubleshooting Problem Possible Cause Solution Plug fuse Replace fuse Worn brushes Have brushes replaced by an authorised GMC service centre operation Power tool fault Contact an authorised GMC service centre Teeth worn or damaged Replace Saw Blade (10) Incorrect Saw Blade type Replace Saw Blade with correct type for material being sawed Cutting performance poor Incorrect Saw Blade specification...