Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Neilsen Manuals
  4. Saw
  5. CT0678
  6. Original instructions manual

Neilsen CT0678 Original Instructions Manual

3 inch air cut-off tool
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
3" AIR CUT-OFF TOOL CT0678
ORIGINAL INSTRUCTIONS
Cannon Tools Limited
Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K.
SAVE THESE INSTRUCTIONS AND PRECAUTIONS.
READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.

Advertisement

loading

Related Manuals for Neilsen CT0678

Summary of Contents for Neilsen CT0678

  • Page 1 3” AIR CUT-OFF TOOL CT0678 ORIGINAL INSTRUCTIONS Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.

  • Page 2: Ec Declaration Of Conformity

    In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: 3” AIR CUT-OFF TOOL Model: CT0678 Applicable EC Directives: EC Machinery Directive 2006/42/EC Harmonized standards EN ISO 11148-7 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K.

  • Page 3: Safety Instructions

    1.SAFETY INSTRUCTIONS •Follow all workshop Health & Safety rules, regulations, and conditions when using tool. •WARNING! Disconnect from air supply before changing cutting disc or servicing. •Maintain tool in good condition and replace any damaged or worn parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
  • Page 4 •DO NOT hold the workpiece by hand. Use clamps or a vice to secure the workpiece. •DO NOT use the tool for a task it is not designed to perform. •WARNING! DO NOT use tool if damaged or faulty. Contact your local service agent.

  • Page 5: Operation

    3. PREPARATION 3.1. Air Supply Recommended hook-up procedure is shown in fig 1. 3.1.1. Ensure tool air valve (or trigger) is in "off" position before connecting to the air supply. 3.1.2. You will require an air pressure of 6.2bar, and an air flow according to specification.

  • Page 6: Maintenance

    4.1.1. Use spanner to secure the shank and unscrew central hex screw with hex key. 4.1.2. Remove the washer and old disc, place the new cutting disc onto the spindle. 4.1.3. Replace the washer and secure with hex screw, but do not over tighten Check that replacement disc is not damaged (cracks, deformations or splinters etc) Also check the mounting washer to ensure it is not deformed, burred or notched.
  • Page 7 a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose connectors. To remedy check the air supply and follow instructions in chapter 3. b) Grit or gum deposits in the tool may also reduce performance. If your model has an air strainer (located in the area of the air inlet), remove the strainer and clean it.
  • Page 8 CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K. Made in China...