Jumper Setting; Connectors And Headers - ECS G41T-M9 Manual

Jumper Setting

Connecting two pins with a jumper cap is SHORT; removing a jumper cap from these
pins, OPEN.
CLR_CMOS: Clear CMOS Jumper
You may need to clear the CMOS memory if the settings in the Setup Utility are
incorrect and prevent your motherboard from operating. To clear the CMOS memory,
disconnect all the power cables from the motherboard and then move the jumper cap
into the CLEAR setting for a few seconds.
1
CLR_CMOS
Note:
1. "Bold white line" on the motherboard indicates Pin1.
2. Before installing this motherboard, make sure jumper CLR_CMOS is
under Normal setting.
3. To avoid the system unstability after clearing CMOS, we recommend
users to enter the main BIOS setting page to "Load Optimal Defaults" and
then "Save Changes and Exit".

Connectors and Headers

1
F_PANEL
HD_LED_P(+)
HD_LED_N(-)
RESET_SW_N(-)
RESET_SW_P(+)
RSVD
1
F_AUDIO PORT1L
PORT1R
PORT2R
SENSE_SEND
PORT2L
1
F_USB1~2
USBPWR0
USB_FP_P0(-)
USB_FP_P0(+)
GND
K E Y
SPDIFO
GND
K E Y
+5V
SPDIFOUT
1
Function Jum per Setting
Normal Short Pins 1-2
Clear CMOS Short Pins 2-3
Connect the case switches and
FP PWR/SLP(+)
FP PWR/SLP(-)
indicator LEDs to the F_PANEL
POWER_SW_P(+)
POWER_SW_N(-)
header.
K E Y
F_AUDIO is for installing auxiliary
GND
PRESENCE#
front-oriented microphone and line-out
Sense1_return
K E Y
ports.
Sense2_return
Use auxiliary USB headers F_USB1~2,
USBPWR1
USB_FP_P1(-)
if your computer case has USB ports
USB_FP_P1(+)
GND
at the front of the case.
USB_FP_OC0
This is an optional header that provides
an SPDIFO (Sony/Philips Digital
Interface) output to digital multimedia
device through optical fiber or coaxial
connector.
6