Selecting The Position For The Outside Temperature Sensor (Optional) - Baxi POWER HT+ 1.50 Installation And Service Manual

Fig.23 Recommended positions for the outside sensor
2
1
Z
1/2 Z
1 Recommended position
2 Possible position
Fig.24 Positions to be avoided for the outside sensor
7609474 - v03 - 15072015
5.3.4 Selecting the position for the outside temperature sensor
(optional)
It is important to select a position that allows the sensor to measure the
outside conditions correctly and effectively.
Place the outside sensor in a position that covers the following character­
istics:
2
1
H
1/2 H (min. 2,5 m)
Avoid placing the outside sensor in a position with the following character­
istics:
C C aution
A second data plate is provided in the instructions bag. The sec­
ond data plate should be affixed to a visible part of the boiler when
installation has been completed. If the boiler is equipped with a
low-loss header kit, a position on the side of the boiler is prefera­
ble.
Recommended positions
On a façade of the area to be heated, on the north if possible.
Half way up the wall of the area to be heated.
Under the influence of changes in the weather.
Protected from direct sunlight.
Easy to access.
1/2 H (min. 2,5 m)
H
H Inhabited height controlled by the sensor
Z Inhabited area controlled by the sensor
Positions to be avoided
Masked by part of the building (balcony, roof, etc.).
Close to a disruptive heat source (sun, chimney, ventilation grid, etc.).
5 Before installation
1
2
MW-8800N001-3
MW-3000014-2
POWER HT + 29