Advertisement
NOTICE
•
Transmission distance is related to wire quality. Please use standard UTP cable and coaxial cable.
•
RJ45 connector and screw push terminal connection mode can not use at the same time. Choose
only one of them.
5. Application Diagram
UTP CAT5 / CAT5e / CAT6
6. Installation Steps
1. Turn off the power of the camera and display before installation.
2. Check if the cables and display device are occupied.
3. Connect monitor or DVR and BNC connectorof the product over coaxial cable
4. Connect the product push terminal UTP cable connector or RJ45 connector and camera output port
over UTP cable.
5. Check whether installation is correct, the device is good, make sure all connection is reliable, connect
power cable, system is power on.
6. Make sure network is normal.
7. Troubleshooting
Please follow below if the device doesn't work:
•
Check if its according to the manual.
•
If you choose RJ-45, make sure both ends of UTP cable are both the same (568A or 568B).
•
If you choose green terminal block, make sure cable of same colour be in the same pin.
•
Check all connections such as BNC, RJ-45.
•
Make sure the real distance doesnt exceed the allowed transmission distance.
•
Make sure the cables are good quality.
•
Replace the device at question by a normal working device.
•
If the problem still occurs, please contact the dealer.
HDUB4P - 4 Channel Passive HD UTP Transciever
Monitor
DVR
Coax
3
Advertisement
