Pride Mobility Mini Crosser Owner's Manual page 29

V I I I . B A S I C
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your PMV are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed below
develops.
NOTE: Your PMV will not run unless the flash code condition is resolved and the PMV has been
turned off, then turned back on.
FLASH CODE
(1) !
(2) !!
(3) !!!
(6) !!!!!!
(7) !!!!!!!
(8) !!!!!!!!
(9) !!!!!!!!!
(10) !!!!!!!!!!
What if all the systems on my PMV seem to be "dead"?
! Make certain that the key is in the "on" position.
! Ensure the freewheel lever is in the drive position.
! Check that the batteries are fully charged.
! Make certain that all battery terminal connections are secured.
! Be sure the power down timer feature hasn't been activated. See VI. "Operation."
! Check all fuses.
Fuse Replacement
In the event a fuse should cease to work:
! Remove the fuse by pulling it out of its slot.
! Examine the fuse to be sure it is blown. See
figures 21 and 21A.
! Insert a new fuse of the proper rating.
WARNING! The replacement fuse must exactly match the rating of the new fuse. Failure
to use properly rated fuses may cause damage to the electrical system and may result in
personal injury.
Mini Crosser
T R O U B L E S H O O T I N G
CONDITION
Battery voltage is too low to operate the
PMV or the charger is operating.
Motor disconnected.
Motor wiring fault.
The PMV is operating with the charger
attached.
Throttle potentiometer fault.
Internal controller fault.
Brake fault—your PMV was left in
freewheel mode.
High battery voltage. The batteries have
been overcharged and the PMV won't
run.
www.pridemobility.com
Charge batteries or unplug the charger power lead from
the electrical outlet.
Check all connections to the motor.
Call your authorized Pride Provider for assistance.
Unplug the charger power lead from the charger port.
Call your authorized Pride Provider for assistance.
Call your authorized Pride Provider for assistance.
Turn the PMV key to the "off" position, then push the
manual freewheel lever to the (down) drive position,
and restart your PMV.
Leave the PMV turned on to drain the batteries to a
sufficient level. If the batteries continue to overcharge,
call your authorized Pride Provider for assistance.
Figure 21. Working Fuse
SOLUTION
Figure 21A. Blown Fuse (Replace)
29