Rear Window Wiper/Washer - Dodge Journey 2018 User Manual

Mist Feature
Push the washer knob, located on the end of the
multifunction lever, inward to the first detent to
activate a single wipe cycle to clear the wind-
shield of road mist or spray from a passing
vehicle. The wipers will continue to operate
until you release the lever.
NOTE:
The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed
on the windshield. The wash function must be
used in order to spray the windshield with
washer fluid.

Rear Window Wiper/Washer

The rear window wiper/washer control is located
on the left side of the steering column.
Rotate the switch upward to the first
detent position for rear wiper operation.
Rotate the switch upward past the first
detent position to activate the rear
washer. The washer pump will continue
to operate as long as the switch is held. Upon
release, the wiper will cycle three times before
returning to the set position.
If the rear wiper is operating when the ignition is
turned to the LOCK position, the wiper will
automatically return to the "park" position.
When the vehicle is restarted, the wiper will
resume function at whichever position the
switch is set at.
CAUTION!
• Turn the windshield wipers off when driv-
ing through an automatic car wash. Dam-
age to the windshield wipers may result if
the wiper control is left in any position
other than off.
• In cold weather, always turn off the wiper
switch and allow the wipers to return to the
park position before turning off the engine.
If the wiper switch is left on and the wipers
freeze to the windshield, damage to the
wiper motor may occur when the vehicle is
restarted.
• Always remove any buildup of snow that
prevents the windshield wiper blades from
returning to the off position. If the wind-
shield wiper control is turned off and the
blades cannot return to the off position,
damage to the wiper motor may occur.
31