The dishwasher does not fill/drain
Problem
Open stopcock
Inlet
Drain
Possible cause and remedy
The tap is turned off.
Turn on the tap fully.
Before rectifying the problem, you must:
Switch the dishwasher off with the button.
Water intake is restricted.
Turn on the tap fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than
30 kPa (0.3 bar).
Seek professional advice.
Before rectifying the problem, you must:
Switch the dishwasher off with the button.
Drain fault.
There is water in the wash cabinet.
Clean the filter combination (see "Cleaning and
care").
Clean the drain pump (see "Maintenance").
Clean the non-return valve (see "Maintenance").
Remove any kink or loop in the drain hose.
Problem solving guide
51