Changing The Battery In Your Transmitter; Transmitter Programming - Silencer 50SL Installation Manual

CHANGING THE BATTERY IN YOUR TRANSMITTERS
SLRF434: The transmitter uses one (1) 3-volt lithium ion battery (#CR2032) with the (+) side facing upward.
To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower
right side of the transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top
case from the bottom case. It should snap apart after breaking the seal. Before removing the battery, note the
direction of the positive (+) terminal. Place the new battery in exactly the same manner, being careful not to
bend or damage the contact terminal. Snap the cases back together and then test the transmitter to insure
it arms and disarms the alarm.
SLRF434 Transmitter Battery Replacement CR2032
+Side DOWN

TRANSMITTER PROGRAMMING

Enter:
1. Turn the Ignition 'switch "OFF/ON" 3 TIMES and stay in ON position. Within 15 seconds.
2. Push the Valet switch 3 times and hold in on the 3
You are now in the Transmitter Programming Mode.
Program:
1. Press any button on transmitter once until the siren responds with a confirming chirp;
the first transmitter is now programmed.
2. Press any button on the second transmitter until the siren responds with a confirming chirp;
the second transmitter is now programmed.
3. Apply the same procedure to program 3rd and 4th transmitters.
Exit: Turn Ignition to the "OFF" position, or leave it for 15 seconds. 3 long chirps and 3 parking light
flashes will confirm exit.
Note: If more than 4 transmitters are programmed, the system will only keep the last four.
IM_FULL_50SL_REV-A
push. When a long chirp, release the valet switch.
rd
11