Multi-Point; Firmware Upgrade - Blueant V1 User Manual

Hide thumbs Also See for V1:

Table of Contents

BlueAnt

Advanced Headset Functions

Pairing your headset with multiple Bluetooth devices

The V1 will connect to 2 phones at a time but 5 devices can be paired to it.

1. Make sure the last phone used has Bluetooth switched off or is out of range.

2. Follow the procedure in 'Pairing Procedure' above for each device you want to pair.

Multi-point

With Multi-point you can connect two phones to the V1 and answer which ever phone rings.

1. Connect: The V1 will connect to the last two phones connected upon powering ON. If you wish to connect a different

previously paired phone, do so from that phones Bluetooth menu. After this the V1 will always connect to that phone.

2. Answer: On an incoming call from either phone, just click the BAB

to answer the call.

3. Answer a second call: Place phone 1 on hold and receive phone 2 by press and holding Vol

for 3 seconds.

4. End the second call: To end phone 2, return to phone 1 on hold, click the BAB

5. Answer phone 2, hang up phone 1: To End phone 1 and answer phone 2 Press and Hold Vol

for 3 seconds.

Note: Redial will dial the ﬁ rst connected phone only.

Note: The Multipoint function does not allow the user to swap from one phone to the other during calls.

The BlueAnt V1 is ﬁ rmware upgradeable via the USB port and provided USB cable.

Please see the support section at www.blueantwireless.com for information and downloads for available upgrades.

Table of Contents