Table of Contents
Advertisement
C
O
M
M
E
R
C
Diagram 13 Tighten the handrail
fasteners.
Handrail end cap
Center handrail
clamp screws (2)
Center console
bracket screws (4)
14. Tighten all the center handrail fasteners. Diagram 13. Start with tightening
the two end cap screws and work inward. See Diagram 13, #1. So that you
don't overtighten the fasteners, hold the supplied hex key by its 3-inch section
and tighten the two center clamp screws. Refer to Diagram 13, #2. Next,
tighten the four console bracket screws. Refer to Diagram 13, #3.
Diagram 14
1
Level the unit.
15. Level the unit. Diagram 14. The C932 has adjustable rear feet. Check to make
sure that the running surface is level (use a bubble level as shown in Diagram
14). If the treadmill is placed on a slightly, uneven surface, adjusting the rear
feet can help, but will not compensate for extremely uneven surfaces.
Important: If you need to make adjustments, adjust one rear foot at a time.
Do not use the rear foot to raise or lower the unit more than ¾-inches.
Check the level of the unit after each adjustment.
16. Adjust the rear deck. Diagram 14, #3. To raise the rear deck, insert the
¼-inch hex key (G). Make sure that the key is fully engaged and turn it
clockwise. Turning the hex key counterclockwise lowers the unit.
I
A
L
P
R
O
D
1
3
U
C
T
S
D
I
V
2
2
3
I
S
I
O
N
page 17
Advertisement
Table of Contents
