Table of Contents
Advertisement
C
O
M
M
E
R
C
a. Place a washer (D) onto each of two ¾-inch screws (C). Thread the screws
through the front panel and into the upright support. See Diagram 6, #2.
Do not fully tighten the screws. Leave room for final adjustments.
CAUTION: Avoid pinching the cable with the bolts and spacers.
b. Place a washer (D) and barrel spacer (B) on each of two 2-inch screws
(A). Insert the screws through the upright support and thread them into
the base mounts. See Diagram 6, #3. Do not securely tighten the screws
until after the unit has been fully assembled.
8. Attach the left side upright support to the base assembly. Diagram 6.
Align the upright support with the base assembly mounting bracket and
secure it by following steps 7a. and 7b.
Install the display
Diagram 7
console.
Display console
Display console
mounting brackets
Upright support
9. Position the display console onto the upright supports. Diagram 7. Make
sure that the cable is routed through the top of the upright support. Have an
assistant hold onto the cable (see inset) and then, rest the display console
on the upright supports and align the mounting holes.
CAUTION: Do not crimp or pinch the cable! Crimped or pinched cables
are not covered by the Precor limited warranty.
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
page 13
Advertisement
Table of Contents
