Advertisement
Note: If proximity linking was not complete in User Setup, the console can still link with the Ant+ sport watch and
HRM during the first 30 seconds of Workout Mode.
Tap the AVG/END button to see your average data values (AVG). The average values show for 5 seconds. To go back to current
measurements more quickly, tap the AVG/END button again.
When the Cadence decreases to less than 5 RPM for 3 seconds or more, the console pauses and the LCD Display shows the last
workout data values. If you stay paused for more than 5 minutes, the workout stops and the console goes to Display Results mode.
To set the STAGE time and STAGE distance back to zero for a new stage in the workout, tap the STAGE button. The TOTAL time and
TOTAL distance continue the total measurement for the workout.
To end the workout, push the AVG/END button and hold for 3 seconds. The console goes to Display Results mode.
Display Results
To stop the workout and go to Display Results Mode, push the AVG/END button and hold it for 3 seconds or longer. The console
shows total Calories, TOTAL time and distance, and the Max and Average values for Speed, Watts, Heart Rate and RPM. The Max
values show first for 5 seconds. Tap the AVG/END button to change between Max and Average values. After 1 minute, the
console sets the values back to zero and goes into Sleep Mode.
Push the AVG/END button and hold for 3 seconds to stop Display Results Mode and go to Sleep Mode.
Device Pairing
Set up Device Pairing for the Console, the Speed Sensor and the Power Sensor (if applicable) before you install them on the bike.
If you add the Power Sensor upgrade to a bike that already has the Console and Speed Sensor installed, it is necessary to set
up Device Pairing again for the console and the 2 sensors. It is necessary to remove the console and sensor from the bike for
access to the pairing buttons.
1. Make sure the batteries are in the console (K1) and the sensors (K2 and K3, if applicable).
Console
Speed Sensor
11 11 11
Advertisement
