Trane TR15REG-DB Operation Manual page 18

The battery represents a risk of high short circuit current. When working on the
battery, always remove watches, rings or other metal objects, and only use tools that
have insulated handles!
Installing, Servicing or Exchanging the Battery should be performed or supervised by knowledgeable
personnel. Battery connection or exchange requires precautions and protective gear. Always wear face and
eye protection with electrical rubber gloves, boots and battery apron. Keep unauthorized personnel away from
battery. When replacing battery, always use the same size battery and number type: 12V, Lead-acid battery.
CAUTION – Do not dispose of battery or batteries in a fire. Batteries are capable of exploding.
CAUTION – Do not open or mutilate the battery. Released electrolytes have been known to be harmful to
skin, eyes and to be toxic.
CAUTION – A battery presents a risk of electrical shock and high short circuit current. The following
precautions are to be observed when working on batteries:
1. Remove watches, rings, or other metal objects.
2. Use tools with insulated handles.
3. Wear rubber gloves, apron, eye protection and boots.
4. Do not lay tools or metal parts on top of batteries.
Make sure the generator set is grounded. Check grounding strap to make sure the generator set ground termi-
nal is securely grounded to a grounding rod.
6. Starting Generator
A. Turn on the power switch (on the left beneath the digital display).
B. Turn on the fuel switch (on the right beneath the digital display).
C. After 10 seconds, press the Manual Start button on the control panel.
D. Press the Auto Start button to initiate system start.
E. Press the Data Check Up and Data Check Down buttons to observe frequency, voltage, speed and the 12V
working voltage and operation time.
7. After the unit has started it will automatically sync with the ATS and enter into automatic mode. The
emergency stop switch, power switch and fuel switch must be kept in the ON position for automatic startup.
8. Inspection of generator set when operating.
Inspect the following systems when operating.
1. Radiator and Coolant level. After warmup, check the coolant flow in system by raising lid to make sure
coolant is circulating. If no coolant is visible flowing through hose to coolant reservoir, shut down the
engine. Allow engine to cool down, and remove the radiator cap.
Checklist:
• Check for fluid and coolant leaks
• Inspect inside and out of the radiator to ensure no excessive dirt is present.
• Check the radiator coils and ensure no dust, dirt or foreign debris exists.
• Check hoses to ensure they are not blocked.
Add additional coolant to recommended levels.
18
032-5095-1A-EN