Impact LX+. The mode should be “Enable+Control”. The other 2 Impact LX+ ports should remain disabled. · Click “Apply” and OK That’s it, setup is now complete and you can move on to the fun part, learning how it all works. Using Nektar Impact LX+ with Reaper www.nektartech.com...
Page 3
Impact LX+ fader will cause it’s display to show {UP}. No data is sent by the fader until you reach value 100 at which point the Reaper parameter will start to move and values will update in the Impact LX+ display. www.nektartech.com Using Nektar Impact LX+ with Reaper...
You can control the Master Volume fader of the Reaper mixer by pressing [Fader button 9] and then move fader 9 while the button is pressed. Upon release of the button, fader 9 will revert to control the current channel volume. LX25+: On Impact LX25+, press [Mixer] and move the [Fader] to control master volume. Using Nektar Impact LX+ with Reaper www.nektartech.com...
Now press [Page] again so the LED labeled “User” is illuminated. The Nektar mapping for this page will typically augment the default mapping so for example you could have oscillator 1 parameters mapped on the Default page and oscillator 2 parameters mapped for the same controls on the User page.
Page 6
4 pad map locations in Impact LX+. To learn how to do that, go to the “Setup Menu” section in this manual. 2016 Nektar Technology, Inc. All rights reserved. Functions and specifications may change at any time. Reaper and Nuendo are trademarks of Steinberg Media Technologies GmbH.