Huawei G510 Maintenance Manual page 42

Figure 9-8 BQ24152 timer start process in charging mode
If the main PCB provides a voltage higher than 1.4 V to the OTG, the maximum current on
the charging interface is limited to 500 mA during initial charging. After the PM8029 detects
the charging process, the system software disables the maximum current limit. The
FAN5402UCX can detect its own temperature as follows:



The FAN5402UCX can detect the charging voltage V
the threshold V
re-determines whether the charging conditions are met. The FAN5402UCX provides various
functions, such as charging overvoltage protection, battery overvoltage protection, battery
detection, and power-on without battery.
Troubleshooting
Fault symptom: The G510 fails to be charged due to either of the following causes:


Handling: Check whether the I/O battery connector is damaged. Troubleshoot the fault
according to the process shown in Figure 9-9.
2013-01-28
G510 Maintenance Manual V1.0
When T reaches the threshold T
J
When T is 10 degrees lower than T
J
When the charging voltage V
(V +V ), the FAN5402UCX enters sleep mode to save electricity.
slp
AUXPWR
(minimum), the G510 stops charging, waits for a certain period, and
IN
A charger is connected to the G510 but the G510 does not respond.
The G510 displays the charging icon on the screen but in fact the battery fails to be
charged.
Huawei Confidential
the charging current is weakened and charging stops.
CF,
, charging restarts.
CF
is smaller than the sleep charging voltage
BUS
constantly. When V
BUS
INTERNAL
is smaller than
BUS
Page 42 of 96