Cisco ASR 14000 Series Command Reference Manual page 323

SONET Controller Commands on Cisco IOS XR Software
report (SONET)
To permit selected SONET alarms to be logged to the console for a SONET controller, use the report
command in SONET/SDH configuration mode. To disable logging of select SONET alarms, use the no
form of this command.
Syntax Description
b1-tca
b2-tca
lais
lrdi
sd-ber
sf-ber
slof
slos
Defaults Alarms from the following keywords are reported by default:
•
•
•
•
•
•
Command Modes
SONET/SDH configuration
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Reporting an alarm means that the alarm can be logged to the console, but it is no guarantee that it will
be logged. SONET alarm hierarchy rules dictate that only the most severe alarm of an alarm group is
reported. Whether an alarm is reported or not, you can check the current state of masked alarm, a
problem indication that is a candidate for an alarm, by displaying the "Masked Alarms" line in the show
controllers sonet command output.
OL-17228-01
report [b1-tca | b2-tca | lais | lrdi | sd-ber | sf-ber | slof | slos]
no report [b1-tca | b2-tca | lais | lrdi | sd-ber | sf-ber | slof | slos]
(Optional) Reports bit 1 (B1) bit error rate (BER) threshold crossing alert (TCA)
errors.
(Optional) Reports bit 2 (B2) BER TCA errors.
(Optional) Reports line alarm indication signal (LAIS) errors.
(Optional) Reports line remote defect indication errors.
(Optional) Reports signal degradation BER errors.
(Optional) Reports signal failure BER errors.
(Optional) Reports section loss of frame (SLOF) errors.
(Optional) Reports section loss of signal (SLOS) errors.
b1-tca
b2-tca
sd-ber
sf-ber
slof
slos
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Cisco ASR 14000 Series Router Interface and Hardware Component Command Reference
report (SONET)
HR-319