Command History Release Release; Usage Guidelines; Task Ids; Encapsulation Ppp - Cisco ASR 14000 Series Command Reference Manual

encapsulation ppp

encapsulation ppp
To enable encapsulation for communication with routers or bridges using the Point-to-Point Protocol
(PPP), use the encapsulation ppp command in interface configuration mode. To disable PPP
encapsulation, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
PPP encapsulation is disabled.
Command Modes Interface configuration
Command History Release
Release 3.7.1

Usage Guidelines

To use this command, you must be in a user group associated with a task group that includes the proper

task IDs.

Use the encapsulation ppp command to enable PPP encapsulation on an interface.
Task ID Task ID
ppp
interface
Examples
The following example shows how to set up PPP encapsulation on interface POS 0/1/0/1:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# interface POS 0/1/0/1
RP/0/RP0/CPU0:router(config-if)# encapsulation ppp
Related Commands Command
show ppp interfaces
Cisco ASR 14000 Series Router Interface and Hardware Component Command Reference
HR-262
encapsulation ppp
no encapsulation ppp
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
read, write
PPP Commands on Cisco IOS XR Software
Description
Displays PPP state information for an interface.
OL-17228-01