Getting Started - AT&T TL91270 User Manual

Getting started

Charger installation
Plug the power adapter into an electrical outlet not
controlled by a wall switch.
IMPORTANT INFORMATION:
1. Use only the power adapter(s) provided with this product. To obtain a replacement, visit our
www.telephones.att.com
website at
1 (866) 288-4268
Canada, dial
2. The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
1 (800) 222-3111
or call . In
.
7
Getting started
Battery installation & charging
Battery charging
Install the battery as shown on the next page. Once you have installed the
battery, the screen indicates the battery status (see table below). If necessary,
place the handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the charger when not in use. The
battery is fully charged after 16 hours of continuous charging. See the table
on page 93 for battery operating times.
If the screen is blank, you need to charge the handset without interruption
for at least 10 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows Low battery and the backlight
is off until you have charged the battery without interruption for at least
one hour. The following table summarizes the battery charge indicators and
actions to take.
Battery indicators Battery status
The screen is blank. Battery has no charge and the
handset cannot be used.
The screen show No battery. Battery is not installed
probably, but the handset is
placed on the telephone base
or charger
The screen shows Place in Battery has very little charge
charger and flashes and the handset cannot be
used.
The screen shows Low Battery has enough charge to
battery and flashes. be used for a short time.
The screen shows HANDSET X Battery is charged.
and the battery icon shows
, or .
NOTE: If you are on a call in low battery mode, you hear four short beeps every minute.
Action
Charge without interruption
until the screen shows Low
battery (at least 10 minutes).
See the Battery installation
section on page 9 for battery
installation.
Charge without interruption
until the screen shows
Low battery (at least four
minutes).
Charge without interruption
until the screen shows
HANDSET X (at least one
hour).
To keep the battery charged,
place it in the telephone
base or charger when not
in use.
8