Battery Recharging; To Replace The Battery - Craig CRT721CW Owner's Manual

PREPARATIONS:

Battery Recharging:

The unit has DC 3.7V Li-ion rechargeable battery and already installed in the battery compartment.
Recharge it before first time use or when it is drained as follows:
1. Connect the small plug from the supplied Connect Cable to the Battery Connection Cable.
2. Connect the full sized USB Plug from the Connection Cable to the USB Port on Personal
Computer or USB Charger (Not included) as illustrated below:
3. Charging will automatically start. The Red Charging Indicator inside the full size USB Plug will
illuminate. When finished charging, the indicator will turn off.

To replace the battery:

If you want replace the installed battery by other new battery (not included), replace it as below:
1. Loosen the screw on the battery door by supplied screwdriver as illustrated below:
2. Press the tab on the battery door then lift it up.
3. Replace the battery.
4. Close the battery door then tighten the screw.
Connect to Personal
Computer or USB Charger
(Computer and USB
Charger not included)
4