Table of Contents
Advertisement
M.
During flying, press the Hi-Low Speed Selection Button repeatedly to set or reset the
speed as desired.
N.
During flying, press the Headless Button to automatically identify where the front of is.
Then slide the Right Joystick upward to fly the unit to it. Press the button again to resume
normal control.
O.
During flying, press the 3D Rolling Button to roll the unit.
7. To stop flying, slide the left Joystick to downward. Wait until the blade stop running and landing.
(On this status, the unit is automatically changed to car mode. Use the Right Joystick to control
the motion of it.)
8. To shut off the Remote Control, press the
not lit.
9. To shout off the unit, slide the Power ON-OFF Switch on the bottom of unit to OFF position. The
decorative LED lights will not lit.
Operation and controls by the Mobile Device:
1.
Recharge the battery and connected it to the DC IN Jack on the unit as previous procedures.
2.
Install the Mobile Device Holder into the Remote Control as Fig 1 below:
(If you don't use the mobile device, you can installed the supplied decorative antenna into the
Remote Control as Fig 2 below)
Mobile Device Holder
3.
Install the mobile device on the holder as Fig 3 & 4 below:
Slide to open the
Holder to fit the
Mobile Device
then lock it:
Power On-Off Button. The Power On Indicator will
Fig 1
Fig 3
Fig 2
8
Decorative Antenna
Fig 4
Hide quick links:
Advertisement
Table of Contents
