Garmin aera 660 Quick Reference Manual page 26

CAUTION: The display uses a lens coated with a special coating that is very sensitive
to abrasive cleaners. AVOID CHEMICAL CLEANERS AND SOLVENTS THAT WILL HARM
THE SPECIAL COATING. It is very important when cleaning the touchscreen to use
a clean, lint-free cloth (lightly dampened with water, if necessary).
CAUTION: The system does not contain any user-serviceable parts. Repairs should
only be made by an authorized Garmin service center. Unauthorized repairs or
modifications could void both the warranty and the pilot's authority to operate
this device under FAA/FCC regulations.
NOTE: This product, its packaging, and its components contain chemicals known
to the State of California to cause cancer, birth defects, or reproductive harm. This
notice is being provided in accordance with California's Proposition 65. If you have
any questions or would like additional information, please refer to our web site at
www.garmin.com/prop65.
NOTE: Interference from satellite repeaters operating inside nearby hangars can
cause an intermittent loss of attitude and heading displays while the aircraft is on
the ground. Moving the aircraft more than 100 yards away from the source of the
interference should alleviate the condition.
NOTE: Use of polarized eyewear may cause the flight displays to appear dim or
blank.
NOTE: Temporary Flight Restriction (TFR) data is provided by the FAA and may
not be updated outside of normal business hours. Confirm data currency through
alternate sources and contact your local FSS for interpretation of TFR data.
4
PROdUCT ENvIRONmENTAl PROGRAmS
Information about Garmin's product recycling program and WEEE, RoHS, REACH, and other
compliance programs can be found at www.garmin.com/aboutGarmin/environment.
dEClARATION Of CONfORmITy
Hereby, Garmin, declares that this product is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC. To view the full Declaration of Conformity, go to
www.garmin.com/compliance.
INdUSTRy CANAdA COmPlIANCE
Category I radiocommunication devices comply with Industry Canada Standard RSS-210,
RSS-247. Category II radiocommunication devices comply with Industry Canada Standard
RSS-310. This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
RAdIO fREqUENCy ExPOSURE
This device is a mobile transmitter and receiver that uses its antenna to send and receive low
levels of radio frequency (RF) energy for voice and/or data communications. The device emits
RF energy below the published limits when operating in its maximum output power mode and
when used with Garmin authorized accessories. To comply with FCC RF exposure compliance
requirements, the device should be mounted per the installation instructions only. The device
should not be used in other configurations. The device must be mounted a minimum of 20 cm
away from the body of the user. This device must not be co-located or operated in conjunction
with any other transmitter or antenna.
fCC COmPlIANCE
This product has been tested and found to comply with Part 15 of the FCC interference limits for Class
B digital devices FOR HOME OR OFFICE USE. These limits are designed to provide more reasonable
protection against harmful interference in a residential installation, and are more stringent than "outdoor"
requirements.
Operation of this device is subject to the following conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.