Configuring RISE
Command or Action
Step 11
switch(config-rise)# show rise
Configuring NSIP on the Appliance
The NetScaler management IP address (NSIP) is the IP address for management and general system access
to the Citrix NetScaler Application Delivery Controller (ADC) appliance and for high availability (HA)
communication.
Configuring NSIP Using the CLI
You can configure the NSIP on your appliance by using either the configuration prompts or the command-line
interface (CLI).
To prevent an attacker from impeding your ability to send packets to the appliance, choose a nonroutable
Note
IP address on your organization's LAN as your appliance IP address.
Before You Begin
Ensure that a port channel is configured on the appliance and that the appliance's physical ports are mapped
to this port channel.
Perform one of the following tasks:
Option
config ns
set ns config -ipaddress address -netmask netmask
add ns ip ip-address netmask -type type
add route network netmask gateway
save ns config
reboot
Example:
The following example shows how to configure the NSIP using the CLI:
set ns config -ipaddress 10.102.29.60 -netmask 255.255.255.0
add ns ip 10.102.29.61 255.255.255.0 -type snip
Purpose
Displays the RISE configuration status on the Cisco Nexus Series switch. If RISE is
configured on the switch, the state that is displayed is "active."
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuring NSIP on the Appliance
Description
Displays prompts for configuring the NSIP.
Configures the NSIP using the CLI.
Configuration Guide
27