Table of Contents
Advertisement
8
Introduction to Bluetooth 'pairing'
With a Bluetooth phone or other device, you must 'pair' the headset
with the device before you use your headset for the first time.
'Pairing' creates a unique wireless link between two Bluetooth
devices, eliminating the need to repeat the pairing process during
future use. The pairing process may vary depending on the device
with which you pair FreeSpeak (see the device's operating guide).
The following section describes how to pair your FreeSpeak headset
to a typical Bluetooth phone.
Pairing to a Bluetooth phone
To pair your FreeSpeak with a Bluetooth phone:
1. Ensure that the FreeSpeak headset is off (see Turning your headset
ON and OFF ).
2. Press and hold down the
until the headset indicator light turns on steadily. (There will be
some short flashes before it goes on steadily.)
3. While the light is still steadily lit, release the
indicator light will remain on, indicating that the FreeSpeak is in
pairing mode and waiting to communicate with another Bluetooth
pairing device.
4. Follow the operating instructions for your Bluetooth phone to start
the pairing process. Typically, this is done by going to a 'setup' or
'connect' menu and then selecting the options to 'discover'
Bluetooth devices. It may take several seconds to establish a
connection.
5. Your phone's display should indicate to you that it found the
' J ABRA BT250' headset and ask if you want to pair it. You should
confirm this.
6. The phone's display should then prompt you for a passkey or PIN.
Enter a sequence of four zeros: 0000.
7. To indicate that pairing has been successful, the headset indicator
light will briefly flash rapidly before it goes back to flashing every
3 seconds (standby mode).
button for approximately 7 seconds
button. The
8. Your phone's display may also ask whether you want to change
the headset's name. If so prompted, we recommend that you
approve the ' J ABRA BT250' name rather than modify it.
9. If the FreeSpeak indicator light is still steadily lit, pairing was
unsuccessful and you will need to turn FreeSpeak off, return
to step 1, and try again.
Attaching the charging cradle clip
The charging cradle can be fastened to a belt or purse using the
supplied clip. To attach the clip:
1. Locate the two slots on the charging cradle as shown below.
2. Position the clip with one flange in one slot. (Ensure that the hinge
of the belt clip is in the same orientation relative to the charging
cradle as shown.)
3. Press clip gently onto the charging cradle until the other flange fits
into the other slot securely. You should hear a clicking sound when
the clip is correctly attached.
1
9
2
3
Advertisement
Table of Contents
